edp
Active
Posts: 8
|
Post by edp on Mar 16, 2019 15:57:27 GMT
When I click on fan links, I used to be able to save the settings, but now it's always grayed out, and I have to redo several fan settings that I am trying to revise. No amount of effort will allow me to save them, and the "SAVE" button is now gray. When I first open the dialog box it's active, then changes to gray. Any ideas where I can look to change this behavior?
|
|
|
Post by siv on Mar 16, 2019 16:43:17 GMT
Welcome to the forum and thank you for taking the time to report this. I wonder how the NZXT got into that state as it should be impossible, can you post Menu->Machine->SIV Setup->SIV Setup AIO and it would also be helpful to see [ Link Status ]. I expect that [ Save ] is greyed as you have invalid modes selected for the NZXT, if you change both the Fan and Pump to say Quiet this should ungrey [ Save ]. After pondering this [ Apply ] should also be greyed so I looked at the code, spotted a typo and from SIV 5.38 Beta-01 it will be.
|
|
edp
Active
Posts: 8
|
Post by edp on Mar 18, 2019 23:59:09 GMT
Welcome to the forum and thank you for taking the time to report this. I wonder how the NZXT got into that state as it should be impossible, can you post Menu->Machine->SIV Setup->SIV Setup AIO and it would also be helpful to see [ Link Status ]I'm happy to. Here you go...
|
|
edp
Active
Posts: 8
|
Post by edp on Mar 19, 2019 0:02:59 GMT
Thanks, I made the change you recommended, and that worked!
|
|
|
Post by siv on Mar 19, 2019 0:13:02 GMT
Good, I am happy to hear it's now working OK. Looking at the screen shot I can see FANS-BID-01-0-Kraken Fan 1 was saved as "2,..." and that is where the mode 2 was coming from, but as [ Save ] is greyed when this happens it can't be saved My guess is that when I first added Kraken support the greying logic was incorrect as I did not have test hardware and this is how it got saved. Looking at [ Link Status ] I can see you have the V2.1.08 firmware and as I have V4.0.03 I am wondering if SIV controls it OK, does it? If not then I guess you will need to use CAM to update the firmware.
|
|